Description
RCBS Bullet Moulds are constructed of the best quality iron. The blocks are ground to achieve an exact tolerance. The locating pins are case hardened to limit wear and to provide permanent alignment for the bullet cavities. Bullet cavities are machined to form a perfect match. The Sprue cutter is a solid steel plate that has been machined to hold firmly against the mould block with an adjustable wave washer. RCBS and Lyman 2 cavity handles will normally fit RCBS moulds. Bullet mould handles not included. AVAILABLE MOULDS: .25-20 Win-85 gr .30-30 Win-150 gr .32 H&R Mag / 32-20 Win- 90 gr CM .38 Special / 357 Mag. 104 gr CM .38 Special/ 357 Mag. 158 gr CM .38-40 WCF-180 gr CM .44-40WCF/.44Russ./.44Spcl/.44Mag.- 200 gr 45 S&W Sch. / 45 Long Colt- 230 gr .56-50 350 gr Spencer CM + Most are Double Cavity design except where noted. + Single Cavity Mould # Gas Check applicable Abbreviation Guide BB – Bevel Base | BPS – Black Powder Silhouette CAV – Cavalry | CM – Cowboy Mould | CN – Conical Nose SPL – Special | CSA – C Sharps Arms | FN – Flat Nose K – Keith Type | M – Minie Ball | PT – Pointed R – Round Ball | RN – Round Nose | SAA – Single Action Army SIL – Silhouette | SP – Semi-Point | SWC – Semi-Wadcutter TG – Target | U – Universal | WC – Wadcutter See Reference Section for Bullet Mould description [PDF] (see HDS Catalog page 85) If the mould is not listed below, consult the Standard and Limited-Production Rifle/Pistol BulletMould sections. California Prop. 65 Warning: Melting lead and casting lead objects (with these products) will expose you and others in the area to lead, which is known to cause birth defects, other reproductive harm, and cancer.
Reviews
There are no reviews yet.